Changing a motorcycle battery

Attach battery negative cable black to battery negative - terminal. Removing the battery is a tricky operation.

Take the new battery and place it in the space where the old one was connecting the valves in the opposite way to disconnection.

Changing a motorcycle battery. Attach your voltmeter leads to the battery terminals start the motor and bring the RPMs to 3000. This should result in a reading of between 138V to 145V. If the reading is below 138V it may be your motorcycles alternator or wiring that is a problem and not your battery.

Once the battery and acid are locked together flip the whole shootin match over and let it drain. Doing it this way prevents the chance of acid spilling if you dont puncture the packs nozzles evenly. Follow the battery manufacturers filling instructions be careful and tackle the task in a well ventilated place or outside.

Take the new battery and place it in the space where the old one was connecting the valves in the opposite way to disconnection. Start wit the positive pole. If you want to read similar articles to When to Change Your Motorcycle Battery we recommend you visit our Motorbike Maintance and Repair category.

Place the fully charged battery into the battery box located within oil tank cavity terminal side forward. Attach battery positive cable red to battery positive terminal. Tighten fastener to 60-70 inch lbs 6879 Nm.

Attach battery negative cable black to battery negative - terminal. Steps to Changing a Motorcycle Battery 1 Locate your existing battery. The battery is typically found under the seat andor behind a side panel.

2 Prepare the new battery. Always use the correct size socket on your socket wrench when removing and replacing the bolts on the battery otherwise you can strip the bolts. Usually you can find your motorcycles battery under the seat but if its not there consult your owners manual to help you locate it.

Remove the negative cable. This video gives step by step instructions along with a visual demonstration of how you can replace the battery on your motorcycle. The motorcycle in this v.

Generally to remove a battery you must disconnect the negative cable first and then the positive cable. Then release the battery from anything connecting it to the motorcycle body and lift it out of the bike. Removing the battery is a tricky operation.

Read the manual before you do anything else. Properly connect the charger to the motorcycle battery. Positive RED charger lead to positive battery post and negative BLACK charger lead to negative battery post.

Unplug the charger or turn it off before you disconnect the leads which will cut down on the chance of the clamps arcing on the terminals. Charge the battery for the amount of time and amperage outlined in the instructions provided. Once charged the battery is ready for use.

Slide the new battery into the battery box on your bike. If the battery cables are dirty or corroded you can clean them up with a wire brush. When reconnecting a battery always attach the positive cable first.

Installing a Motorcycle Battery Getting a new battery in your motorcycle is basically the reverse of the process you used to get the old one out. Once you slide the battery in reconnect the cables. This time attach the positive first making sure to include any accessory connections and then the negative.

Before you replace your dead lead-acid battery you should check the state of your bikes charging system particularly on older bikes. There might be a problem that caused the previous battery to fail. A healthy motorcycle charging system puts out about 14 volts at 2000 rpm and a lithium battery needs between 13 and 14 volts to charge.

See reviews photos directions phone numbers and more for the best Motorcycles Motor Scooters-Parts Supplies in San Mateo CA. Get that battery out to charge it. Though not absolutely necessary its a good precaution when putting a charge to a battery that might be dead.

Removing the battery is also a good idea because the temperature of a battery changes when being charged. When the road calls trust us with your motorcycle battery. Find your fit today.

Factory-Activated AGM Powersports Batteries. Interstates factory-activated absorbed glass-mat AGM powersports batteries are fully charged sealed and ready to use. They can be mounted at virtually any angle without spilling leaks or water to check.

Motorcycle battery replacements have to fit into the aperture that your previous battery came from. Most popular motorcycle models will have exact match replacements available both OEM and aftermarket.